The paint on the aluminum body of the Lofrans Windlass was peeling and bubbling, so I removed it from the boat to work on it as a winter project. I’ve last removed it over 10 years ago when I removed the motor to have it serviced when we were in Tahiti. It has worked flawlessly but I figured as long as I had it removed for painting, I would also service the motor and clutch.
Painting
My original thought was to have the aluminum casing powder coated. There are 2 parts to the casing–one that encloses the motor (dry) and one that encloses the internal gears (oil-filled). In order to powder coat them, I would need to remove the internal gears and the motor since powder coating involves dipping the metal in pigment particles and baking it in an oven. Since I could not pull the inner cone clutch or the rope gypsy off the shaft, I wasn’t able to remove the internal gears. Not wanting to turn this project into something bigger and possibly damaging something, I decided to pivot and paint the casings myself (also, the quote I got was $500 for the powder coating!).
The first step was to strip the old paint. I used a chemical stripper and a lot of scraping and sanding to remove all the old paint. Some of it pealed off easily but much of it required several applications of the chemical stripper. After cleaning with TSP, I brushed on 4 coats of Rust-oleum Topside Marine Coating gloss white, lightly sanding between each coat.




Servicing the Motor
The windlass has a high torque electric motor with 4 brushes. After removing the outer casing, I carefully lifted the springs to remove and inspect the 4 brushes. Since there was plenty of carbon left, they didn’t need replacing. I blew out the carbon dust with a can of air, then used electrical contact spray to clean out the brush casings, stator, and commutator. Next I used 600 grit wet/dry sandpaper to polish the commutator back to shiny copper. I reassembled it and applied some lithium grease on the bolt threads.

Motor (before cleaning)
Reinstalling
After reattaching the motor housing to the main body, I added 17 oz of gear oil (PennGrade 80W-90 GL-4). I cleaned the inside of the sightglass so now the oil level is visible. I greased the cone clutch with a thin coat of lithium grease, applied a thin layer of silicon to the base before bolting it back down to the bowsprit, and applied lithium grease to the 3 electrical lugs.

